Features:
|
|
Easy To Apply In 4 Simple Steps:
![]() |
![]() |
![]() |
![]() |
| STEP 1: | STEP 2: | STEP 3: | STEP 4: |
STEP 1:
Clean the surface area very well to remove all road film, wax or other meterial
that may prevent a film bond. Allow to dry before applying.
STEP 2:
With a tape measure and masking tape, lay down a strait line of making tape the
entire length of the vehicle. The bottom edge of the tape should be where you
want the upper edge of the molding.
STEP 3:
You will want a 1/8" gap at each door edge. Starting at the front of your
vehicle, measure the section of molding you will need to reach that gap. Use
pruning shears or a sharp knife to bevel-cut the molding at a 45 degree angle.
STEP 4:
Press the molding along the bottom edge of your tape line. Refer to step 3 and 4
as you do each section. Do not wash vehicle for 24 hours.