Style Guard Chrome & Black Side Molding (1-1/8" x 7ft.)

Easy To Apply In 4 Simple Steps:

STEP 1:	STEP 2:	STEP 3:	STEP 4:

STEP 1: Clean the surface area very well to remove all road film, wax or other material that may prevent a film bond.
Allow to dry before applying.

STEP 2: With a tape measure and masking tape, lay down a straight line of masking tape the entire length of the vehicle.
The bottom edge of the tape should be where you want the upper edge of the molding.

STEP 3: You will want a 1/8" gap at each door edge. Starting at the front of your vehicle,
measure the section of molding you will need to reach that gap. Use pruning shears
or a sharp knife to bevel-cut the molding at a 45 degree angle.

STEP 4: Press the molding along the bottom edge of your tape line.
Refer to step 3 and 4 as you do each section. Do not wash vehicle for 24 hours.