CTA Tools 2-1/4" Bearing Separator

• Removes generator gears, bearings, bearing cones
  and similar parts where ordinary puller jaws will not reach

• Knife-like edges

• Minimize damage to parts

• Range: Up to 2-1/4" / 57mm

Instructions:

• Use with regular gear puller or by itself
  where wedging action is needed

• Remove nuts from bolts and separate the two halves of the splitter

• Reassemble splitter so that the sharp edges are
  placed behind the bearing or gear that is being pulled

• Tighten the nuts

• Note: in some cases the wedging action of the splitter
  is all that is needed to release the bearing or gear

• Attach a puller so the jaws are securely attached to the back
  of the splitter, then use the pulling action of the puller
  until the bearing or gear has been released