Why should I replace the brake wear sensor wire when changing pads?

It's recommended to replace the brake wear sensor wire when changing pads because the sensor is designed to wear down with the pad. If your old sensor is already worn, it might not give accurate readings or could fail soon after new pads are installed.

What temperature can this brake sensor wire withstand?

This DFC brake sensor wire is engineered from high-temperature resistant materials and can withstand operating temperatures up to 500 degrees Fahrenheit.

Does this brake sensor wire come with any hardware?

This brake sensor wire comes new in the box and is ready to install. No additional hardware is typically required for installation as it's designed to be a direct replacement for the original part.

DFC 19-21 Porsche Macan Front Sensor Wire

1 / 3

Specifications

Brand: DFC
Part #: 341-02055
UPC: 194873659387

DFC 19-21 Porsche Macan Front Sensor Wire

Name: DFC 19-21 Porsche Macan Front Sensor Wire
Brand: DFC
Price: 5.62 USD
Availability: InStock

$5.62

Only 4 left in stock

Fits 2019-2025 Porsche Macan. This front brake sensor wire accurately monitors pad wear.

Key Features

Fits 2019-2025 Porsche Macan.
Made from high-temperature resistant materials, handling up to 500degF.
Features highly conductive electrodes for accurate monitoring of brake pad wear.
Designed to match the form, fit, and function of the original equipment sensor wire.
Comes new in the box and is ready to install without modifications.
Quality tested to ensure long-lasting performance.

⚠️ CA WARNING: This product can expose you to chemicals known to the State of California to cause cancer and/or birth defects or other reproductive harm. Learn more

Secure CheckoutFast Shipping631-982-0042

Fits this vehicle

Porsche Macan 2019-2025

Product Details

When you're replacing the brake pads on your 2019-2025 Porsche Macan, it's a good idea to swap out the brake wear sensor wire too. This little wire plugs into your caliper and tells your dashboard when your brake pads are getting low, so you know when it's time for a new set. If your old one is damaged or you're just doing a full brake job, this replacement is what you need.

DFC makes this sensor wire from materials that can handle the heat generated by your brakes, up to 500 degrees Fahrenheit. It's built with conductive electrodes that accurately read the pad wear level, so you get a reliable warning when your pads are getting thin. It's made to fit and function just like the original equipment part, meaning it'll install without any fuss or modifications needed.

This sensor wire comes new in the box, ready to go. It's been quality tested to make sure it lasts and does its job properly, giving you peace of mind that your brake warning system will work when you need it to.