Forced Performance Mitsubishi Evo 9 Red Turbocharger Ball Bearing MHI Turbine Housing w/o WG

The MHI turbine housing on this Forced Performance Red turbocharger is cast from a high-nickel alloy, a material chosen for its ability to withstand the extreme temperatures found in the exhaust stream of a performance Mitsubishi Evo 9. This housing is specifically designed to work with the ball-bearing CHRA, which significantly reduces friction compared to traditional journal bearings. This means quicker spool-up and a more responsive feel when you get on the throttle, especially at lower RPMs.

This turbocharger features a 73mm inducer and 84mm exducer compressor wheel, paired with a 67mm exducer turbine wheel. The housing's A/R ratio is set at 0.73, a balance that helps deliver strong top-end power while still allowing for a reasonably quick response. It's built to handle the demands of a tuned Evo 9, offering a notable step up in airflow over stock components. This unit is designed as a direct replacement for the factory turbocharger, simplifying the installation process for those looking to upgrade their Evo 9's forced induction system.

When installing this turbocharger, ensure all oil and coolant lines are properly flushed and free of debris to protect the ball bearings. It's also recommended to have a proper tuning solution in place to take full advantage of the increased airflow and to ensure the engine operates safely. This turbocharger is not CARB approved and cannot be shipped to California.