SPC Performance 2 deg. CAMBER/CASTER SLV

When you're getting an alignment, sometimes the stock adjustment range just isn't enough to dial in your front suspension. This SPC Performance sleeve is what you get in the box to help achieve that. It's designed to easily change both camber and caster angles on many Ford and Mazda rear-wheel drive and four-wheel drive trucks, helping you get your alignment just right.

The sleeve itself is made from steel and features a clear zinc coating to resist corrosion, so it'll hold up well under your truck. For RWD vehicles, you can expect to adjust camber and caster by up to 2 degrees. On 4WD models, the adjustment range is about 1.4 degrees. To get the most accurate alignment, SPC recommends using their zero-degree sleeve (part number 23199) to determine your starting point before installing this 2-degree sleeve.

Installing these sleeves is pretty straightforward. You'll typically loosen the upper ball joint pinch bolt, remove any snap ring, and then use a sleeve puller tool to remove the old sleeve and install the new one. It's a good idea to have a sleeve puller, like the 77880, on hand before you start.