DFC 03-04 Audi RS6 Right Front Drilled Hi-Carbon Alloy Geomet Coated Rotor

DFC is known for making well-built brake components, and this right front drilled rotor for your 2003 Audi RS6 is a prime example. If you're looking to replace worn-out rotors on your high-performance sedan, this part is designed to handle the demands of the RS6's braking system. It's built with G3000/G11H18 iron castings, which are chosen for their strength and stability, ensuring the rotor can withstand the heat generated during hard stops without warping.

This rotor features an original equipment (OE) vane configuration, meaning it's shaped to help dissipate heat effectively, keeping your brakes cooler and performing better. It's also precision mill-balanced to within 0.010 MM for disc thickness variation and 0.050 MM for lateral runout. This careful balancing means you'll experience smoother stopping with no unwanted vibrations, even at higher speeds. The fine-turned finish, measured at 16 RMS, helps your new brake pads bed in properly for optimal initial performance. Plus, the Geomet coating offers robust corrosion protection, keeping the rotor looking good and functioning well for longer, especially in areas where road salt is used.

When installing these rotors, remember that proper break-in is key to their performance and longevity. Refer to the manufacturer's installation instructions for the recommended procedure. This rotor is sold individually, so be sure to order two if you're replacing both sides.