Armor All Ultra Shine Headlight Restoration Wipes (6 Wipes)

• Cleans oxidation from
  your headlights

• UV sealant wipe leaves
  a lasting protective coating

• No tools or sandpaper needed

• Includes:
  - 4 oxidation removal wipes
  - 2 UV sealant protection wipes

DIRECTIONS:

Step 1: Oxidation Removal

• Make sure your headlights are
  clean and dry

• First apply the cleaning wipe

• Keep wipe folded to reduce evaporation

• Scrub headlight with firm, even pressure
  in a horizontal back-and-forth motion

• Oxidation residue will begin
  to be removed

• Turn the wipe to a clean side,
  keeping the wipe folded

• Continue to wipe, turning wipe to clean section
  as needed until no residue is visible on wipe

• Discard wipe

• Open a second cleaning wipe
  and continue wiping back and forth
  with firm  pressure for at least 2 minutes

• Your headlight may appear clear but
  additional deep cleaning is necessary
  to ensure all oxidation is removed

• Note: Avoid contact with any painted surface.
  Use painter's tape to cover any painted surface
  around the headlight

Step 2: UV Sealant Protection

• Ensure your headlights is dry

• Wipe surface them with a clean,
  lint-free towel

• Apply the UV protectant wipe
  to your headlights

• Wipe in one direction, similar to
  applying a coat of paint

• One wipe will coat two headlights

• Let surface dry completely
  (will be dry to touch in about 3 hours)

• Do not touch surface and avoid
  contact with water until dry

•  If spotting or streaking occurs from
  water contact before fully dry,
  repeat steps 1 and 2 with a fresh wipe

• Note: Drying time after Step 2 is dependent
  upon weather conditions.  Drying may take longer
  in lower temperatures or higher humidity